Return-Path: Received: from [65.33.86.188] (account ) by logan.com (CommuniGate Pro WebUser 4.0.2) with HTTP id 1893223 for ; Mon, 02 Dec 2002 22:03:45 -0500 From: "Marvin Kaye" Subject: Re: [LML] LNC2 Friction in Roll Control To: lml X-Mailer: CommuniGate Pro Web Mailer v.4.0.2 Date: Mon, 02 Dec 2002 22:03:45 -0500 Message-ID: In-Reply-To: <003801c29a6a$3561adc0$6601a8c0@cruzio.com> MIME-Version: 1.0 Content-Type: text/plain; charset="ISO-8859-1"; format="flowed" Content-Transfer-Encoding: 8bit Posted for "Dave Saylor" : Lee, Your instincts are good in treating this pretty seriously. Control friction can be a sign off really bad problems. I wouldn't fly until you figure out what's wrong. It sounds like you may have a bad rod end or bearing. Try simulating the flight loads by pushing up on both ailerons at the same time from the neutral position. It may take three of you. When you move the stick, listen for any strange noises and otherwise see if you can duplicate the friction. It might mean a pretty time consuming search. Rod ends are really good at transmitting motion when they're in good condition, but they can get very draggy when they start to fail. Also, check to make sure there is no sign of interference at the aileron leading edge, top and bottom. It's common to try to close the gap as much as possible, but zero clearance too close! You should swing the gear in the hangar and make sure there's not any interference from a hose, cylinder, or some other component. The scariest aileron binding I've seen involved an S-Tec servo in the wing of a 320. This all happened on the ground, but I shudder to think about it locking up in flight. The builder had neglected to install the required stops, thereby allowing the motor to rotate endlessly as it searched for its commanded heading. As it hunted the stick would slowly cycle left to right over and over. The problem came when the power was shut off with the stick at full deflection. Then, with the servo input rod at its 3 or 9 o'clock position, parallel to the aileron pushrod, it would very effectively lock the aileron control full left or right. I imagined a situation where the AP started hunting for some reason, and as the plane quickly rolled farther and farther, the pilot shut off the autopilot or master switch to make it stop. That would lock it in place for good. We installed the correct stop bolt per a Glasair installation manual which solved the problem. Anyway, your problem sounds more like friction and not full lockup, but it might not hurt to check for the stops. Let us know what you find. Good Luck, Dave Saylor AirCrafters LLC www.AirCraftersLLC.com 831-722-9141 >>>>One real noticeable difference, however, is in the freedom of movement of the stick in roll while in flight.<<<