Well, I recently bought a used aluminum flywheel with the
following description:
Quote:
RX7 8.5Lb Fidanza Aluminum
Flywheel for FB or FC
For sale is a 8.5lb Aluminum Fidanza Flywheel for a
RX7 Non Turbo , its used and could use a new friction plate
fits 86-91 Non turbo RX7s
might fit Fb 2nd gen RX7s as well i'm not 100% sure
Unquote.
It was reasonably priced, since I don't need the wear surface,
so I figured it would be 'plan B' if I ever have an issue with
the flex plate.
When it arrived (yesterday, after everyone was gone), I sat it
on top of my (cracked) flex plate, and it's almost an inch
smaller in diameter. The mounting holes in the center seem to
line up properly. I remember reading about milling the drive
plate to move the starter .2" closer to the engine, but I
don't remember anything about the smaller diameter.
So, my questions:
Did I purchase the wrong item, would I simply make my starter
cutout in the plate closer to the centerline to account for
the smaller diameter, or was the flywheel mis-represented?
If it's not the described item, I need to send it back, but I
don't want to bother the seller if I simply bought the wrong
flywheel.
Thanks,
Charlie