|
Message
I'm at the point where I'm trying to start my (3rd gen
turbo LS1 coils) engine for the first time.
I turned the engine for about a minute. It made no
attempt to fire at all, so I removed a plug, grounded the side against the block
and looked for a spark while cranking. Nothing. I checked the hot pin on the LS1
coil, and it had 12v. The other 3 pins seemed to be grounded. Other than
rechecking ALL the EC2 connections I'm not sure where to go from
here.
Hi John. As careful as I thought I was when I hooked up
my EC-2, I made some mistakes. I would be willing to bet that you'll find
a simple wiring error, rather than something actually
broken. Did you install the recommended injector disable
switches? I'd look there first. BTW, they aren't off are they
:-) Believe it or not, I know a guy, who has a friend, who
tried and tried to crank his engine one day, only to find that his injector
switches were in the disable position. What a dumbass... OK, it
was me :-)
Good luck,
Rusty (I want to hear engine noise again
myself)
|