Charlie,

My Renesis engine on the test stand uses the same injectors that Richard has.  Today, I recorded some data that should indicate whether or not these injectors might work for your application.  At 23" MAP, fuel pressure of 40 psi, and 5265 RPM, the fuel flow was 10.6 gal/hr and the pulse width on all four injectors was 4.4 ms.  From this data, it appears that those injectors should support a fuel flow of slightly over 20 gal/hr at 6500 RPM with an injector duty cycle of less than 80%.  It would be good if you (or anyone else) would independently check if my calculation is reasonable.

Steve

Hi Richard,

The only info I could find on the green ones seems to indicate that they are 230cc. I can't find numbers for the brown, but based on the model number, they are probably slightly larger. I suspect, but don't actually know, that I need 400+cc(normally aspirated Renesis). The yellows are somewhere between 380 & 430 cc, depending on where you look & what pressure they run at.

Thanks for checking, & if it turns out that my research is wrong on the flow figures, we'll need to talk further. :-)

Charlie