Joe,
Thanks for the
Photos of your Toyota waterpump installation.............I think I have a
3rd
gen sensor bracket also.........Will have to check at the
hangar..........Photo attached shows
the bracket and sensors on
a 3rd gen front cover...........IMHO you would be
time ahead if
you can round up a 3rd gen front cover............I will check wth
some of the guys I get parts
from.........I will send the bracket with the trigger wheel when I get
it..............
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_
Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50
Turbo
From: josrph berki
<jskmberki@windstream.net>
To: Rotary motors in aircraft
<flyrotary@lancaironline.net>
Sent: Thursday, June 23, 2011 6:26
PM
Subject: [FlyRotary]
Ignition sensor location
Does anyone know where the CAS sensor
is located with respect to the timing
mark on a third gen engine?
From what I measured one of the studs on a 3rd
gen cover that locate the
sensor bracket is 42 degrees from the timing mark.
I do not know if I will
use this cover and fab a sensor bracket and buy some
sensors or just fab a
bracke for the 2nd gen cover and use the 3rd gen
trigger wheel.
Thanks for any help.
Joe Berki
Limo
EZ
--
Homepage: http://www.flyrotary.com/
Archive and
UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html