Joe,
Thanks for the Photos of your Toyota waterpump installation.............I think I have a 3rd
gen sensor bracket also.........Will have to check at the hangar..........Photo attached shows
the bracket and sensors on a 3rd gen front cover...........IMHO you would be time ahead if
you can round up a 3rd gen front cover............I will check wth some of the guys I get parts
from.........I will send the bracket with the trigger wheel when I get it..............
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: josrph berki <jskmberki@windstream.net>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Thursday, June 23, 2011 6:26 PM
Subject: [FlyRotary] Ignition sensor location
Does anyone know where the CAS sensor is located with respect to the timing
mark on a third gen engine? From what I measured one of the studs on a 3rd
gen cover that locate the sensor bracket is 42 degrees from the
timing mark.
I do not know if I will use this cover and fab a sensor bracket and buy some
sensors or just fab a bracke for the 2nd gen cover and use the 3rd gen
trigger wheel. Thanks for any help.
Joe Berki
Limo EZ
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html