Mailing List flyrotary@lancaironline.net Message #51856
From: Dennis Havarlah <clouduster@austin.rr.com>
Subject: Re: [FlyRotary] Re: Hushpower failures
Date: Wed, 4 Aug 2010 16:48:23 -0500
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Re: [FlyRotary] Re: Hushpower failures
Steve -
My pictures are on another computer and not easily retrieved currently.  The Van's RVaitor news letter had an article and good pictures.  Go to Van's web site and look at page 9 - 11 of the first issue in 2010.  The top left picture on page 10 shows the exhaust system and my original intake.  The top right picture is the new intake manifold I installed in 2009.
 
Dennis H.
----- Original Message -----
Sent: Wednesday, August 04, 2010 1:43 AM
Subject: [FlyRotary] Re: Hushpower failures

Dennis, do you have photos of your setup, particularly of your intake?
Cheers

Steve Izett
Building Glasair SII RG Renesis 4 Port RD1-C EC2 EM3


On 4/08/10 12:16 PM, "Dennis Havarlah" <clouduster@austin.rr.com> wrote:

My Hushpower resonator ( short hushpower) is still going - 250 hours on Renesis and LOVE IT!!   Everyone that hears my fly by comments on how quiet the plane is.  About 10 hours ago I removed the muffler and removed the few peices of the baffle still inside.  I never saw any performancy decrease due to blockage as it failed.  Now it is only an enlarged muffler shell  in the exhaust system.  My neighbors tell me it is no louder and the tone of the exhaust is a little deeper.

My 4 inch dia. tangantial pipe (used to turn the exhaust 180 deg.) is still doing fine with no signs of any failure.  This is located foward (toward the prop) and is fed by the factory exhaust maifold.  This system combined with the split side flange exhaust of the Renesis makes for a very easy to control exhaust.


As far as Renesis Horsepower goes - I have a Catto 76X88 porp and RD1-C PSRU on my RV-7A - I pretty well match my neighbor"s RV-7A with a Lycoming 180 engine with dual electronic ignition.  
 
 
The following has been addressed before but I'll repeat it based on my experience.
I use 0.5 to 0.7 oz of WalMart outboard oil and Marvel mixed half and half  per gallon of regular grade Mogas.  Cost is about $12.00/gal for the oil mixture.   In cruise I use 8 - 9 gph and at 0.6 oz/gal I would burn 213 gallons of Mogas for each gallon of oil.  Mogas is about $1.00 cheaper than 100 LL.  With the oil cost figures included I save $200 in fuel cost when I fly 213/9 = 23.6 hours.
 
My dual fuel pumps are in the cabin, foward of the seats on the floor.  I have never had any fuel vapor problems - even in Texas in the summer.  
 
Hope this helps some.
 
Dennis Haverlah


 
 
 


 
Has anyone had their hushpower muffler fail, and if so, how did they  fail?
 
 
 
Thanks,
 
Brian Trubee



-



The contents of this email are confidential and intended only for the named recipients of this e-mail. If you have received this e-mail in error, you are hereby notified that any use, reproduction, disclosure or distribution or the information contained in this e-mail is prohibited. Please notify the sender immediately and then delete/destroy the e-mail and any printed copies. All liability for viruses is excluded to the fullest extent of the law.
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster