I noticed quite a while ago and have mentioned
several times here that my engine does not have a linear response to throttle.
It reaches its max power before it reaches fully open throttle. I havent
worried too much about this up until now because the airplane has sufficient
power as is, has slightly better performance than my previous 160HP Lyc
powered -6A, and my wood prop is actually a pretty good match for the current
power level.
But I would like to understand what's going on
here and eventually address it. I was flying yesterday, my usual boring holes
in the sky directly over the airport. Decided to investigate just a little so
leveled at 5,000 feet at full throttle. Started reducing throttle until I
noticed a slight reduction in RPM and fuel flow. Then looked down at where the
throttle was actually set and was shocked to see it slightly below half open.
I dont have a regular manifold pressure gauge, just an industrial type vacuum
gauge ( I really gotta get an MP gauge). Anyway, the vacuum gauge was
indicating 4" of vacuum.
So I suspect I am giving up a substantial amount
of HP. I think the most likely suspect is my throttle body. For a throttle
body I copied Tracy's original design. Started with a stock late 80s
Mazda TB and hacked off the third port and all of the extra stuff. The cowl in
this area is very tight and I am unable to install any sort of air filter or
any sort of bell mouth on the TB. And I'm sure the cowl's close proximity to
the TB influences airflow into it as well.
Any comments on this or ways to test it are
welcome.
Mike Wills
RV-4
N144MW