Wankelers, As I posted before, my one data point experience with the
> rotary, The Harbor Freight engine stand ($39.95 on sale) fits the
> rotary from the flywheel side if you are using the auto trans flex
> plate. All you need are four 10 X 1.75 X 75 mm bolts. Trim about 10mm
> (3/8") from the threads on the two you use for the bottom two holes.
> The hollow dowels in the end plate fit right into the arms of the
> engine stand. When your done using it, it breaks down nicely for storage.
>
> Rick Girard
I think the threads in the end housing are 10mm x 1.25mm (thread pitch).
Tracy
Oops! Tracy's right. Just measured the bolts with an SPI metric thread gage. They are 10 X 1.25 X 75mm. Hope nobody raced out to buy.
Rick Girard