|
Then I would guess you have an open or short in the
sensors.
Bill Schertz
KIS Cruiser #4045
N343BS
----- Original Message -----
Sent: Thursday, October 02, 2008 9:18
AM
Subject: [FlyRotary] Re: Testing...one,
two, three...
Yes, #2 is coolant after rads, #3 is oil in the pan & I checked the
settings in EM2 for cal. are correct from specs supplied by Tracy.
Thanks, David R Cook
--------------
Original message --------------
From: "Bill Schertz" <wschertz@comcast.net>
Do you have a sensor hooked up to fluid temp
2&3?
Bill Schertz
KIS Cruiser #4045
N343BS
----- Original Message -----
Sent: Wednesday, October 01, 2008
9:45 AM
Subject: [FlyRotary] Re:
Testing...one, two, three...
Been busy running eng./mapping fuel, what is NOP on Tracy's EM2
on fluid temp 2&3 ? Also have problem with temp readings
for coolant & oil, showing 65400 degreas F. ?
David R Cook RV6A Rotary, Michgan getting cold.
--------------
Original message --------------
From: "The Mallorys" <candtmallory@cebridge.net>
I’ve
been busy building. My o-rings and seals from RWS got here
yesterday, and today I finished painting the housings. Tomorrow I
start reassembly.
Chris
From: Rotary
motors in aircraft [mailto:flyrotary@lancaironline.net] On Behalf Of
Mark Steitle
Sent: Tuesday, September 30, 2008 11:30
AM
To: Rotary motors in aircraft
Subject:
[FlyRotary] Re: Testing...one, two, three...
Receiving loud and clear... I guess everyone is
busy either building or flying.
On Tue, Sep 30, 2008 at 10:45 AM, <DLOMHEIM@aol.com>
wrote:
The
list has gone silent (on my end) since 26 Sep, so just checking to make
sure there wasn't a problem on my end, etc.
|