Mailing List flyrotary@lancaironline.net Message #43889
From: George Lendich <lendich@optusnet.com.au>
Subject: Re: [FlyRotary] Re: New rotary engine-mazda points on design
Date: Sun, 7 Sep 2008 11:45:35 +1000
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
 That's good feed back Ben. I have myself suggested the Bing selection is not such a good one. I believe that some use Mikuni carbs as a replacement. I also notice with the Jabiru supplied Bing there is no leaning knob, perhaps their afraid of losing valves. The Jabiru supplied carb kit was running very rich mixtures and only recently have they offered replacement (and leaner) jets as a modification.
 
I've flown a 4 seat Jabiru and the six cylinder is very strong and very good climb performance. However I agree with the advice and so glad my opinion is supported. However some claim the benefit of altitude compensation, but I believe that's only good up to certain heights.
 
I have been lucky enough to have recently worked on a RV 7 with the Bendix type ( constant feed) fuel injection system - only 30 psi. It looks simple enough and runs of a mechanical pump - can be run off an electric pump as well, so I'm told.
 
Thanks again for the comment.
George (down under)
George,
A friend of mine is flying his Kitfox with a Jabiru 2200. He had some trouble with his carburetor leaking and took it to the FBO. The guy looked at it and told him they used to run the Bing carburetor on motorcyles years ago and now throw them in the scrap pile. I think the Jab is a great engine, however, EFI would make it sing like your Suzuki.
Ben
 
 
----- Original Message -----
Sent: Saturday, September 06, 2008 5:50 PM
Subject: [FlyRotary] Re: New rotary engine-mazda points on design

Tracy,
I must be missing a point somewhere, or we have crossed wires, as I haven't mentioned the combustion chamber. My only concern is high pressure fuel leak in flight. Don't get me wrong I like fuel injection because of the control over injection volume and performance. I only wish there was high pressure at the point of injection - only.
 
I have fuel injection on my Suzuki 1800 Motorbike and it's great, but I would hate to have to work on it, like I did on the old carbied bike.
 
I've noticed the Jabiru are running a very simple system. Their using a Honda ignition module with an altitude compensating carby - not that the system is perfect either.
George ( down under)
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster