Too Late, Bobby, I calculated based on a 19" width
{:>)
I have sent the coordinate graphs to your e mail as they
are a tad larger than Marv permits. I had to embed them in a MS word
document - tried converting to jpeg with PaintBrush but it didn't work
out.
So the one with Height data is looking at the duct from
the side (assuming the core is mounted with the core face perpendicular to the
direction of flight). The Width data is looking at the duct from
top/bottom. So if you shaped a foam core to these coordinates and then
rounded the edges to smooth corners, this should give you a good duct for your
core.
Things come together at the inlet around 8-9" with a 10"
wide opening and a 3" wide opening - for cosmetic reasons you could make the
opening slightly wider and height slightly less just so they give you an opening
around 30 sq inches. So that looks like about 1.5" above/below
center line for a 3" total and 5" left/right of center line for a 10" width at
about 8-10" out from the core.
The streamline duct is to be preferred over my Pinched
duct where possible, but once you start getting shorter than about 6" the
truncated Streamline duct starts to show a lot of the core to the airstream and
it is my opinion the drag goes up considerably. The pinched duct is
basically a compromise duct for those with very short 3-6" duct runner
space.
Hope this helps.
Ed
----- Original Message -----
Sent: Monday, July 16, 2007 5:26 PM
Subject: [FlyRotary] Re: Oil cooler
duct.
Ed,
My notes say 18".
Bobby
Hi Bobby,
You actually have sufficient distance to probably come
pretty close to a streamline duct. Tell me how wide the core you
may use from Ed - the same 19" as the stock or different? I'll see what
I can come up with.
Ed
----- Original Message -----
Sent: Monday, July 16, 2007 3:30
PM
Subject: [FlyRotary] Oil cooler
duct.
Ed,
It looks like I
have about 10-12 inches of duct between the chin scoop and oil cooler face.
The cooler is a stock mazda but I am considering a slightly larger one that
Ed K. makes. 6.5" tall vs 5" Any suggestions on how you would shape
this duct using the pinched duct approach?
Thanks....
Bobby
----- Original Message -----
Sent: Monday, July 16, 2007 5:26 PM
Subject: [FlyRotary] Re: Oil cooler
duct.
Ed,
My notes say 18".
Bobby
Hi Bobby,
You actually have sufficient distance to probably come
pretty close to a streamline duct. Tell me how wide the core you
may use from Ed - the same 19" as the stock or different? I'll see what
I can come up with.
Ed
----- Original Message -----
Sent: Monday, July 16, 2007 3:30
PM
Subject: [FlyRotary] Oil cooler
duct.
Ed,
It looks like I
have about 10-12 inches of duct between the chin scoop and oil cooler face.
The cooler is a stock mazda but I am considering a slightly larger one that
Ed K. makes. 6.5" tall vs 5" Any suggestions on how you would shape
this duct using the pinched duct approach?
Thanks....
Bobby
--
Homepage: http://www.flyrotary.com/
Archive
and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html