|
Message
Or you can
buy the setup from MazdaTrix for about 40-45$ In one of
the photos showing the inlets to Paul's manifold you can see the ends of the
1/2" aluminum rods plugging the block injector holes.
Thanks for the description,
and also the tip about Mazdatrix. It took some looking but I found the
plug kit you mentioned. This is probably the way I'll go.
I used a 3/8"
flange and bolted to his manifold, but most people weld the tubes into it.
However they are using thick pipes rather than tubes. I brazed my tubes to
the flange and then bolted it to the manifold, so I could take it off (if things
did not work out with that manifold).
Amazing how you answered
my exact question before I even asked
it.
Thanks again, oh keeper of
valuable knowledge :-)
Rusty
|