Received-SPF: pass
 receiver=logan.com; client-ip=24.214.63.101; envelope-from=rv7rotary@knology.net
From: "Chris Sargent" <rv7rotary@knology.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Subject: Corrosion products from McMaster-Carr
Date: Sat, 27 May 2006 08:59:09 -0500
Message-ID: <KIEKIKNMEGHGFCNPIGPBIEDFDFAA.rv7rotary@knology.net>
MIME-Version: 1.0
Content-Type: text/plain;
	charset="us-ascii"
Content-Transfer-Encoding: 7bit
Importance: Normal
In-Reply-To: <list-1129850@logan.com>

McMaster-Carr's catalog has several corrosion-inhibiting products.

http://www.mcmaster.com/

Type in "1985" for the page number.

Chris Sargent

-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]On
Behalf Of Bulent Aliev
Sent: Friday, May 26, 2006 10:21 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Another case of heat-soaked coils?

Another good corrosion inhibitor is Boshield made by Boeing. Used it
in marine environment for years. Contains wax that leaves protective
film. Do not use WD-40. It is useless for this purpose since
evaporates quite quickly.
Buly
On May 26, 2006, at 10:41 PM, Tracy Crook wrote:

> Thought the coils were a long shot.
>
> I'm still not sure where the connection that failed was (connector
> contact or the unknown connection at the end of the pigtail left by
> cutting the connector off the Mazda harness) but I do like treating
> all connector contacts with a corrosion inhibitor.  My favorite is
> Corrosion X.   I like soldered connections for this reason too.
> I'll do my own stress relief to get it away from the potential
> stiff connection at the solder joint.  To each his own though.
>
> Tracy  (Granddaughter gone for the summer,     Aahhhh.......... : )
> -


--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/