Rusty,

   Mine does not, but there is a pair of holes - above and
below the throttle plate - I think they were intended to
be connected via an idle bleed motor.  I planned to seal
them off with a blank plate, where the motor/solenoid
went.  It should be a trivial matter to drill through the
plate into the lower cavity to use that as a MAP port.

   I won't be doing that on mine; I want to sample the
intake pressure about mid-runner on each of the four
tubes.

Dale R.


 
Russell Duffy <13brv3@bellsouth.net> wrote:
 
>    Did you mean the bolt pattern.  Mine (nom. 60mm bore)
> is pretty close to 90mm x 90mm.
>
>  
> Thanks Dale.  The overall dimensions is what I was after, to the 90mm x 90mm
> bolt pattern gives me a pretty good idea.  Does it have a MAP port?
>  
> Cheers,
> Rusty
>
>
>
>
>
>
>