|
Ken I screwed up on reporting the rotor slot width, it should be 2.17 to 2.26mm not 2.017 to 2.026mm
Georges
-------Original Message-------
Date: 04/17/05 07:51:53
Subject: [FlyRotary] Re: New rotors, New housings
-------------- Original message from keltro@att.net (Kelly Troyer): --------------
Georges,
Are these numbers in reference to the apex seal slot taper from
the bottom of slot (2.017 mm) to the top of slot (2.026 mm) which
is a taper of (.009 mm) or about 3.54 thousands here in the 48 ??
--
Kelly Troyer
Dyke Delta/13B/RD1C/EC2
-------------- Original message from "Echo Lake Fishing Resort (Georges Boucher)" <echolakeresort@telus.net>: --------------
|
Correction, the readings were 2.017 to 2.026mm
Georges
-------Original Message-------
Date: 04/16/05 19:05:31
Subject: [FlyRotary] Re: New rotors, New housings
|
Hi! Ken
Do you you cut on a taper, where does your taper start? or do you just skim 0.015" off each side for a total of 0.030". I just measured the two rotors that were in a "GOOD" running 92 13b NA & got a reading of 0.017 to 0.026mm, I guess they are toast.
Georges Boucher
-------Original Message-------
|
|
|