-------------- Original message from keltro@att.net (Kelly Troyer): --------------

Georges,

    Are these numbers in reference to the apex seal slot taper from

the bottom of slot (2.017 mm) to the top of slot (2.026 mm) which

is a taper of (.009 mm) or about 3.54 thousands here in the 48 ??

--
Kelly Troyer
Dyke Delta/13B/RD1C/EC2

-------------- Original message from "Echo Lake Fishing Resort (Georges Boucher)" <echolakeresort@telus.net>: --------------

Correction, the readings were 2.017 to 2.026mm Georges     -------Original Message-------   From: Rotary motors in aircraft Date: 04/16/05 19:05:31 To: Rotary motors in aircraft Subject: [FlyRotary] Re: New rotors, New housings    Hi! Ken Do you you cut on a taper, where does your taper start? or do you just skim 0.015" off each side for a total of 0.030". I just measured the two rotors that were in a "GOOD" running 92 13b NA & got a reading of 0.017 to 0.026mm, I guess they are toast.    Georges Boucher -------Original Message-------