----- Original Message -----
Sent: Friday, April 15, 2005 10:28
AM
Subject: [FlyRotary] Re: New rotors, New
housings
Ed,
Pineapple did my 3mm rotor work. It was
done fairly fast, and done well.
Barny
----- Original Message -----
Sent: Friday, April 15, 2005 9:20
AM
Subject: [FlyRotary] New rotors, New
housings
Well, the decision has been made. Thanks
in part to the wife's continued interest in my warm body on cold
winter nights, the decision has been made to purchase new rotors and rotor
housings. $$ but apparently I am worth it {:>)
I looked into milling out the slots to 3mm and
that would have been the cheaper approach - but cheap approach is probably
partly responsible for me being in this situation - so going to try a
different approach this time. Besides leery of using a rotor which
clearly has been subjected to sufficient loads to scrape metal off its
surface and peen over apex slot.
In the process of getting quotes.
Ed
This message scanned for viruses
by CoreComm