|
Thanks, Perry.....I'll try to find a local welder
and cut the pieces myself with a hacksaw. Thanks.. Paul
Conner
----- Original Message -----
Sent: Saturday, June 07, 2003 9:33
AM
Subject: [FlyRotary] Re: Fuel Header
Tank
Paul, that is where my sump tank is located, on the firewall
below the spar opposite side from the engine. Originally it was on the engine
side, so I made it out of steel. Holds about 1 gallon and has two Mazda fuel
pumps inside, fuel return is to this sump tank like Ed's. The selected main
flows to this sump tank by gravity so it is mounted low.
Maybe you can
find a local welder in your area that can weld aluminum. I found a guy near me
that does. I take water pump parts, intake manifold parts, etc. to him for
welding. I just tell him they are for my RX-7. Design it yourself, get the
sheet aluminum, cut out the pieces, and take it to the welder. I think 6061 is
good for welding but 2024 is not.
|