Ron, thanks, I had looked at XRP before but didn't recognize the ORB (O
ring Boss ) connectors as being what I needed. After having you recommend it
again, I found this site that describes all the different thypes of fittings
Bill Schertz
KIS Cruiser # 4045
----- Original Message -----
From: Ron Milligan [mailto:ronmilligan@cox.net]
Sent: 9/15/2004 11:23:09 AM
To: flyrotary@lancaironline.net
Subject: [FlyRotary] Re: Fuel Pump Fittings
Have you tried Summit Racing: http://store.summitracing.com/
Or Livermore
Performance: http://www.livermoreperformance.com/XRP_Adapters.html#Adapters
Ron Milligan
RV7 QB Fuse
Aliso Viejo CA
From: Rotary
motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Bill Schertz
Sent: Wednesday, September 15,
2004 11:16 AM
To: Rotary motors in aircraft
Subject: [FlyRotary] Fuel Pump
Fittings
I purchased the fuel pumps from Tracy,
one end is a hard hose connection, the other end has a screw in brass hose
nipple, and could be replaced with a screw in fitting. That is what I would
like to do, but:
I haven't found a source for the fitting. The threads are 3/8-24, and I
would like to go to AN-4 or 6.
Anyone have a recommendation of where to get the fitting?