|
|
Here are some pictures of a cut down water pump (from the "other" list) I
did mine essentially the same way. Use a band saw to cut off the neck at an
angle, I used a router bit to take out the divider, then welded in a new
divider and welded on an outlet tube.
----- Original Message -----
From: "Marvin Kaye" <marv@lancaironline.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Saturday, March 15, 2003 8:46 AM
Subject: [FlyRotary] Re: EWP is out, parts needed
> Posted for "William" <wschertz@ispwest.com>:
>
> The aluminum water pump casting can be welded by someone who can weld
> aluminum. You can see mine in the picture.
>
> Bill Schertz
>
> >>> I'm now looking at that tall thermostat cover housing, and wondering
what
> the best way to cut that down would be. Can this cast aluminum be
welded?<<<
>
> >> Homepage: http://www.flyrotary.com/
|
|