|
Message
Greetings,
I mentioned that I need to
make a sleeve to adapt the MSD injectors to the holes in the center
housing. I was trying to find a stock piece of steel (or anything else
that will work) tubing that had an ID of .55", and an OD greater than
.65". The plan would be to put this on the lathe, and turn the OD down to
a nice fit in the holes in the block. As it turns out, 14mm is almost
exactly .55", and certainly close enough for the o-ring seal that will go
there.
Searching the internet, the
only place I found that has this is Parker Steel International, and they're
a wholesale only place, requiring tax exempt numbers, minimum orders, etc.
Does anyone know where I can get 14mm ID tubing that would work for
this?
Thanks,
Rusty (in search of a
better GPS display)
|