|
|
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
<< Lancair Builders' Mail List >>
<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
In a message dated 06/02/2001 1:05:03 AM Eastern Daylight Time,
lancair.list@olsusa.com writes:
<< OK I was tired that night and typed breaker point where I should have
typed RELAY point. The whole point (pun?) was that you should have some way
to kill that pump motor if it runs away or are just testing the emergency
dump. >>
I apologize if I seemed too snappish. Yes, you're absolutely right, and
there have been numerous reports of relay failures in this forum already
(though most have been fail-to-operate, rather than fail-to-shut-off, I
think). The ways to minimize these relay failures have been noted as well --
Bosch relays, continuous-duty relays, zener diodes, other diodes, etc, and I
won't list them here.
I understood that the pump should be turned off during the monthly alternate
gear extension test. The manual suggests pulling the relay circuit breaker
(to keep the pump from turning on), but not pulling the pump breaker, and
then dumping hydraulic pressure using the manual dump valve. I never
understood this. I had planned on pulling my single circuit breaker, cutting
power to both the pump and the relays, and then opening the dump valve.
I'd appreciate any comments on this proposed test procedure. If I've missed
something important I'd like to know.
By the way, I learned a while ago that I should not send work-related e-mails
after 5 pm. I'm too tired and I ended up pissing people off needlessly with
quick responses. I haven't followed that rule in this forum since I get my
digests late in the evening and usually respond right away. Too bad, since
as a general rule I value the respect of my fellow Lancair builders more than
that of my employers. (Maybe I need a new job...)
- Rob Wolf
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website: http://www.olsusa.com/Users/Mkaye/maillist.html
LML Builders' Bookstore: http://www.buildersbooks.com/lancair
Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
|
|