Dan, my engine is doing the same thing. One thing to try is putting your "last" to peak injector in #2 cylinder. #2 is the hardest cylinder to cool in my plane as well. This may cause you to fly quite lean if you cruise "lean of peak. Two,
check your fuel rate at 2500 rpm and 31.5 inHg. I think at full rich it should be approx 32 gph and mine is way below that. I have 43.5 gph at 2700 rpm and 38.4 inHg. It appears I may need to pull the fuel pump and check the calibration. I'm trying to find
fuel flow rate data for the TSIO550 right now.
The current engine I have is brand new with approximately 20 hours on it. It has a standard mixture control and replaced the previous FADEC controlled engine.
I can not seem to correct my number 2 CHT problem. The previous engine did not seem to have the problem to this extent. The mod of building a recess in the oil cooler plenum was done long ago.
I cannot climb with 31.5" MP, full rich without #2 hitting 400F at about 11,000 feet. Climb speed is 165 knots. Today's ground temp was 70F. I have made a clear path for the air by relocating hoses, spark plug leads, brackets
and anything that might disturb the cooling air. The only thing left to move is the air conditioning hoses which are right in the way of the air as it enters the cowling.
All the baffling is very tight and everything is the same as was on the other engine.
Has any one had to use a larger injector to keep number 2 cool. Number 2 EGT is the first to peak. All the other 5 CHT's run within 3 degrees of each other with number 2 being about 25 degrees higher. EGT's are running in
the 1450 range with #2 being the hottest.
Straight and level at 17,000 feet indicating over 200 knots the #2 CHT will stay just under 400 degrees 31.5" and full rich. When I try to lean it out the TIT's start above 1650.
Has anyone got any suggestions?
I will be looking at the injectors tomorrow.
I wonder what the trade in value of a slightly used red knob control cable is?
Dan Reagan
IVP 670 hours and wishing I had my FADEC back