You can change the numbers while the autopilot is engaged. Do this slowly, set progressively higher numbers until the autopilot over controls then back off a couple of numbers. This is now a good point to make small changes from if necessary. My sorcerer works well in my IVPT. At top speed it does overshoot larger angle turns in route but does correct back. I'm told that Trutrak offers an autopilot for VLJ's that would work better in the IVPT.

 

Dave.

 

 

In a message dated 7/31/2008 12:22:25 P.M. Pacific Daylight Time, colyncase@earthlink.net writes:

What settings are working for IVP drivers.

Factory setup is:

LAT=Activity 12, torque 12, micro 5

VRT= Activity 4, torque 12, micro 2

 

That's how I am running mine.  It's way sloppy.