|
Message
I am replacing my
4200 series Slick Magnetos on my Lancair 320 powered by a Lycoming
O-320-E2D engine. I need to remove the drive gear from the shaft of the
magneto and transfer the drive gear to the new magnetos. I have
successfully removed the cotter pin from the castle nut on the end of the
shaft. How do I remove the castle nut from the drive gear? I need
some means to hold the shaft of the magneto while I'm trying to break the castle
nut free. Any suggestions?
Once I get the nut
free and install the drive gear on the new magnetos, what is the tightening
torque for the castle nut?
One final question,
where can I purchase the Slick locating pin that aligns the magneto prior to
installation in the engine?
Don Gordon
Lancair
320 - N320DS
Orlando,
FL
|