<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>
In a message dated 9/13/99 9:42:38 PM, you wrote:

<<how to best prevent the hydraulic lines on the floor from
abrading one another?>>

I used Click-Bond fasteners to bond 10-32 studs to the fuselage.  An Adel
clamp attached to the stud secures the hydraulic lines in my LNC2.  The
Click-bonds are pricey if you buy them from Aircraft Spruce, but direct from
the factory they're only about $3 each.

- Rob Wolf


[I did something similar, I call it my poor-man's Click-Bond...  I
locate the adel clamp where I want it to go and spot drill into the
interior skin through the mounting hole.  After all the clamps have
been located I remove the tubing and open up the holes with a 3/4" hole
saw, being careful to only cut the inner skin.  I remove the BID circle
and core out the area plus ~1/8" under the edge and bed a hardware store
bolt that has flats ground on the edges of its head into flox inside the
skin.  I put a 1-BID over it and let it cure. Voila... almost instant
studs at a fraction of the cost of Click-Bonds.  It actually goes a lot
faster than you can tell about it.  FWIW          <Marv>        ]
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/Users/Mkaye/maillist.html