Sender: <marv@lancaironline.net>
To: lml@lancaironline.net
Date: Thu, 15 Dec 2005 22:11:04 -0500
Message-ID: <redirect-884321@logan.com>
Received-SPF: none
 receiver=logan.com; client-ip=205.152.59.65; envelope-from=aadamson@highrf.com
From: "Alan K. Adamson" <aadamson@highrf.com>
Subject: Adjustable rudder floors
MIME-Version: 1.0
Content-Type: text/plain;
	charset="US-ASCII"
Content-Transfer-Encoding: 7bit
Thread-Index: AcYB6hSzS9NYbxrAQuypy0pNhUanzg==

Ok, before I got hacking these floors up.  Are they just impossible to fit?
It doesn't mater what I do, mine are either too wide, or not shaped
correctly.  They kinda buckle between the nose wheel well and the engine
mount bulkhead or they don't have the right taper to the contour of the
fuselage at the rear where the load pads are installed.  They are going to
take some serious hacking to get to the "level" placement that is specified
in the manual and then they may need some big time gap filling in certain
places.

Justin, I've also got a question, are these suppose to be fit to each kit
number?  For example, my kit is number 284 and yet I have floors that are
numbered 217.  Perhaps this is just inventory related and these just come
out of a mold, but these aren't even close!

:(... And I was doing so good too until this popped up.

Alan