Posted for "glong2" <glong2@netzero.net>:

 Mike:
 
 I have followed the discussion with interest. Next time I am at the airport
 & have time I will use your method to see how my wings compare.
 
 I have the slow build kit and my jigs were built from plywood using a NC
 mill. The jigs should have been accurate to .001. The mill was programmed
 using the CAD drawings from Lancair. The Lancair drawing themselves are not
 correct in that the lines for the templates do not always intersect - off at
 most by ~ .010, but had to be corrected before the NC software would accept
 it. I built 2 sets of jigs so I could build both wings at the same time and
 get them as symmetrical as possible.
 
 I will let you know how my measurements come out.
 
 Eugene Long
 Lancair Super ES
 glong2@netzero.net