|
Hello I am trying to hook up a Garmin 295 to a Electronics
International FP-5L fuel totalizer. They don't want to talk to one
another.Here is what happens when I push the F.to DES or the F. RES button:
The unit will read "off" for a second then go to "on" and never change from
that state. There is no hash mark on the display. I tried NMEA Out, RTCM
In/NMEA Out Both have a 4800 bard rate. The RTCM In/NMEA Out Said that it is
Scanning at a freq. of around 300.0 khz (this changes) also a bit rate of
100 that changes to 200 and back again. The status says "scanning" for 10
sec then says Check Wiring. I did check the wiring and it is OK.
The FP-5L is setup to receive the format (In3) and output is setup for
an output of OT2.
I was wondering if anyone has had a similar problem? If so what did you
do?
Jack Plavcan
N235U
autumn@lightstream.net
|
|