Return-Path: Received: from smtp2.erols.com ([207.172.3.235]) by truman.olsusa.com (Post.Office MTA v3.1.2 release (PO203-101c) ID# 0-44819U2500L250S0) with ESMTP id AAA21881 for ; Tue, 3 Nov 1998 12:26:01 -0500 Received: from preinstalledcom (207-172-194-188.s61.as2.grn.erols.com [207.172.194.188]) by smtp2.erols.com (8.8.8/8.8.5) with SMTP id MAA03237; Tue, 3 Nov 1998 12:27:06 -0500 (EST) Message-ID: <363F3B00.3994@erols.com> Date: Tue, 03 Nov 1998 12:18:56 -0500 From: "Jeffrey B. Chipetine" Reply-To: abcrental@erols.com To: lancair.list@olsusa.com CC: abcrental@erols.com Subject: OIL BLOWBY X-Mailing-List: lancair.list@olsusa.com Mime-Version: 1.0 <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> << Lancair Builders' Mail List >> <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>> >> Dan Dudley's inquiry about oil blowby in Lycoming 320's is not uncommon as any Cessna 172 lowly (low-life?)spam-can owner (like me!)can attest. The Cessna Pilot's Association's John Frank has an informative artical on this problem on the CPA Website, unfortunately, it is on the "Members Only" side. CPA email address is info@cessna.org This is one of the neatest groups I've come into contact with. Very much like this group, they have an esprit c'corps and share information freely for the common good. Possibilities on oil discharge 1) too much oil...when overfilled, 1st qt will blow out within 30 minutes ( article comments that the higher sump capacity may be to account for the longest range tanks forseen as used by the assorted aircraft onto which the engine may be affixed. Good notes there on how to go about establishing a STABILIZED oil level. I would really reccomend that you inquire of the C.P.A. for a reprint as it is valuable and I don't want a copyright suit on my hands. 2) Cyl walls pitted or worn at mid cylinder. (borescope to check). 3) piston rings stuck or misalligned. 4) leaking front crankcase seal(they harden over time and fold back..not readily visable) allows crancase to pressurize and oil blows out breather. 5) BREATHER LINE OUTPUT LOCATED IN LOW PRESSURE ZONE ON AIRCRAFT CAUSING A SUCTION TO BE CAUSED (common on the Cessna 201, homebuilts on a case by case basis) 6) if wet vac pump installed, a clogged oil return line will cause air/oil seperator to vent through the breather. Note: while the oil capacity of my C-172 w Lyc 320 is 8 qts, it blows out till I get to 6 1/2 then stabilizes at about 1qt/10 hrs. Much cheaper not to overfill and throw the oil out the breather and very nice not to be cleaning the belly of the plane once a week!. regards to all. Build Safe.. Jeffrey B. Chipetine