At 07:17 PM 6/20/2004 -0400, you wrote:

 

----- Original Message -----

From: DaveLeonard

To: Rotary motors in aircraft

Sent: Sunday, June 20, 2004 4:05 PM

Subject: [FlyRotary] LS1 Coil Connector

Hey you guys, with all this chatter you could have built your own.  This was

a good job to give my wife.  I taught her to solder and she had them done an

hour later on one of those rare evenings she came to help.  I poured in a

little resin to fill the space, and later topped it off with some RTV to

soften the transition.  Cost: $0.

Dave Leonard (a true Tracy Crook disciple)

I'll take that as a high complement Dave.  Yes, a good solder joint with proper strain relief is more reliable than any connector and cheaper to boot.  Good idea on the RTV topping, I didn't think of that!

 

Tracy

True, but not quite as easy to remove the coil(s). 

Mark S.