Mailing List flyrotary@lancaironline.net Message #67156
From: Finn Lassen finn.lassen@verizon.net <flyrotary@lancaironline.net>
Subject: Re: [FlyRotary] EC2/3 Mixture Correction Table
Date: Thu, 17 Feb 2022 11:10:40 -0500
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
You're still way ahead of me.

I thought I had auto-tuned all tables. Yet found it going lean when added throttle to climb around 4,200+ RPM. Disconcerting. Could be change in AOA influences intake. Need to fly and tune more. Only 33 hours in the air so far. And yet now have to do annual condition inspection :(
About 3 shots of prime in 80F + temps. More in colder temps.

Finn


On 2/17/2022 3:42 AM, Stephen Izett stephen.izett@gmail.com wrote:
Hi Guys

I’m using an EC2 with an 8 table MCT

Ive never adjusted the early table entries that only get used during those initial moments at startup.
Our Renesis 4 port, at startup initially runs just below 1500 rpm and over the next ~ 30 seconds warms and then idles at our desired 1800 rpm. The RD1C can make some noise if we lower that idle.

As its pretty tricky to get mixture readings as the engine first fires up, I’m wondering if anyone has experimented with playing with those early addresses of the MCT and found this has made for a sweeter startup.

Also on startup I have settled into giving 4-5 priming shots when the engine is cold. And only a few when warm. It takes double or triple the revolutions to start when warmed up.

Our OAT is generally somewhere between 60-85F

I’m wondering what others with similar warmer climbs have found is the best technique.

Thanks

Steve Izett
Perth Western Australia





--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster