Mailing List flyrotary@lancaironline.net Message #67144
From: Kelly Troyer keltro@gmail.com <flyrotary@lancaironline.net>
Subject: Re: [FlyRotary] Re: Oil Pressure
Date: Mon, 7 Feb 2022 20:27:32 -0600
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Stephen,
I seem to remember that the pressure recommendation for the RPM's our flying engines run that the pressure also be bumped up to 80 + PSI probably this info was from Lynn Hanover..........I also
believe that Tracy's problem was an "O" ring...........The 13BREW engines were running stock at 100 + PSI (Went down some as the oil warmed up and got a little air in it)..........Your pressures seem 
a bit low overall particularly for a flying Rotary............IMHO.........<:)
Best,
Kelly Troyer

On Mon, Feb 7, 2022 at 7:55 PM Charlie England ceengland7@gmail.com <flyrotary@lancaironline.net> wrote:
On 2/7/2022 7:17 PM, Stephen Izett stephen.izett@gmail.com wrote:
More data on oil pressures going back in time

Hobbs  T Off     Lowest

27.4     69        48

34.9     69        48

36.9     70        46

46.3     65        48

59.8     66        49

67.7     68        47

70.6     65        35


So they look pretty consistent until the last flight.
I haven’t checked the sender.
I did do a rewire of sender wiring. I will check this however the pressure at Take off was within the range of previous temps (Lowest of the previous readings)

Can anyone comment on the reasons and their probability for lower oil pressure?
I believe the Renesis 4 port has only one oil pressure regulation valve. 

Cheers

Steve

On 8 Feb 2022, at 7:29 am, Stephen Izett stephen.izett@gmail.com <flyrotary@lancaironline.net> wrote:


Hi guys

I’ve just noticed that my oil pressure on the last flight dropped lower than ever before.

At takeoff 7000 rpm with an oil temp of 71C (160F) it peeks at 65 psi (according to the sender) then drops off as Oil temp peeked at 100C (212F) with a pressure of 35 psi.
During the flight as the oil temp dropped to 86C (187F) the oil pressure was then 55 psi.
Pressure appears independent of rpm and closely tracks oil temp.
I can’t recall the weight of the oil I’m presently using.
Engine is a standard unmodified Renesis 4 port except the mod to replace the thermal pellet in the e shaft.

Would appreciate your thoughts and numbers.

Steve Izett
IIRC, Tracy had similar symptoms when an O ring in the oil path into the accessory case failed. Can't recall if it was in the early 13B or the Renesis. It's been a long time, so my memory may be flaky. Should be something in the archives.

Charlie

Virus-free. www.avast.com


--
Kelly Troyer
Dyke Delta_"Eventually"
13B_RD1C_EC2_EM2
Image
RX8-oil-engine-sys.jpeg
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster