Mailing List flyrotary@lancaironline.net Message #66294
From: James Whitehurst flyboyusvi@gmail.com <flyrotary@lancaironline.net>
Subject: RE: [FlyRotary] Re: Turbos.........
Date: Sun, 30 Aug 2020 15:04:53 -0400
To: Rotary motors in aircraft <flyrotary@lancaironline.net>

Neil, answer… Billet inc, as a result of connections my motor builder had! I think both of us would make different choices the second time around! Very happy with my motor builder! Have you integrated a c/spd Gov Pad on your PSRU yet? I need 2 soon!!! Oh yes, they need to be up to surviving 350 hp for take off occasionally. -james whitehurst

 

Sent from Mail for Windows 10

 

From: 12348ung@gmail.com
Sent: Sunday, August 30, 2020 4:56 AM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Turbos.........

 

James,

                 Who in OZ did you buy from?  Neil.

 

From: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Sunday, August 30, 2020 12:58 PM
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Subject: [FlyRotary] Re: Turbos.........

 

Charlie, my airframe will be : Twin fuselage Amphibian (2p+2s, Tandem seating), twin pusher (Billet 13b, P-Port), on retractable skis (water ops), imbedded tires (land ops), carbon fiber(much/most cored sandwich). Oh yes…my design!  1”:12’ scale electric RC model tested on calm water so far. Starboard half, skeleton full scale  plug on floor now… waiting on engines for nacelle shape integration. They are a year late. Buying from

Australia was slow! Hope to use Neil’s 3.12 reduction if it can be beefed up to hold the HP. Yes it is truly EXPERIMENTAL! -James whitehurst

 

Sent from Mail for Windows 10

 

From: Charlie England ceengland7@gmail.com
Sent: Friday, August 28, 2020 12:53 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Turbos.......

 

James, 

 

What  is your airframe?

 

Charlie

 

Image removed by sender.

Virus-free. www.avast.com

 

On Fri, Aug 28, 2020 at 11:40 AM James Whitehurst flyboyusvi@gmail.com <flyrotary@lancaironline.net> wrote:

??? Above 10,000 ft? I couldn’t figure out how… so I just received my Borg Warner EFR9280 Turbos with water and oil cooled ctr aluminum housing. I know its more complex but I figure I’ll have the HP to 18,000’.   Comments enjoyed?   James whitehurst

 

Sent from Mail for Windows 10

 

From: lehanover lehanover@aol.com
Sent: Friday, August 28, 2020 9:47 AM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Turbos.........

 

As you can see on this dyno sheet much power is available where most folks like to run aircraft Rotaries.

 

The ports you see in that picture are designed to operate best at 9,400 RPM, at 250HP, however that is a 12-A engine.

2292 CCs vice 2900 CCs for a 13-B, so more power from a 13-B. So ports designed for best power at say 5,500 RPM would have a shorter top (Closing Point) and a smaller bridge opening. I do not let any of the side seal ends to cross over the port so side seal damage is not a factor. So very nearly stock service life minus the wear you would expect from spending hours of operation at full throttle. With synthetic 2 cycle oil in the fuel and in the sump I suspect (but do not know) about 500 to 1,000 hours. A hot compression check or a hot

leakdown test will tell the tail........LEH 

 

In a message dated 8/28/2020 7:31:58 AM Eastern Standard Time, flyrotary@lancaironline.net writes:

 

One word....Turbo normalizing. Ok that's two words, but that's my plan.

 

In your opinion, how reliable is a bridge port engine? At what RPM do you see the benefits?

Les Criscillo

Pilot, Brewmaster, Maker

From: Rotary motors in aircraft <flyrotary@lancaironline.net> on behalf of lehanover lehanover@aol.com <flyrotary@lancaironline.net>
Sent: Thursday, August 27, 2020 9:34:07 PM
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Subject: [FlyRotary] Turbos.........

 

We don't need no stinking turbos.....when we can have 250HP bridge ports......

 

Lynn E. Hanover

 

 

Image removed by sender.

Virus-free. www.avast.com

 

 

 

Image
5B42C5A420744326844A3BC640258760.jpg
Image
C1E8D46B4C354C2390B9D6CDEBD9A25C.png
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster