Mailing List flyrotary@lancaironline.net Message #66201
From: William Jepson wrjjrs@gmail.com <flyrotary@lancaironline.net>
Subject: Re: [FlyRotary] Testing best rpm power setting
Date: Thu, 6 Aug 2020 09:17:08 -0700
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Steve,
On the dyno you will know better, but on the 4 port (stock) you should see peak power at less than 7k. On the small port version of Powersport’s p-port with a similar intake length they were seeing best power at about 6,500. They may have been slightly over-proped. I would expect a similar max power with standard side ports. Or possibly even lower rpm.
Bill 

On Thu, Aug 6, 2020 at 7:59 AM Stephen Izett stephen.izett@gmail.com <flyrotary@lancaironline.net> wrote:
Hi guys

I’m wanting to inflight test for the best RPM for peak power of our 4 port Renesis with variable pitch prop (No constant speed control at present).
On Takeoff at Full Fine we hit 6900 after a few seconds and then rpm builds to 7400 by 500 feet and 110 KIAS
I’m wondering if we are well past the peak torque and would be better off at a lower rpm.

Am I right in thinking the following would use the aircraft as a Dyno to establish rpm for best power?

1. Set up level flight (auto pilot)
2. Maintain WOT and constant mixture (best power - say 0.9 Lambda - 13.2 AFR) via Wideband O2
3. Vary RPM in 200rpm increments for 2 minutes each setting between 5600 and 7200 by adjusting prop pitch
4. Note Fuel Flow and IAS (Logged on Dynon Skyview)

I’m thinking this would give me an indication of best RPM for highest power.
Our Inlet is just under 19” long, measured from the side face of the engine.
So I’m thinking peak torque may be around  6400 rpm.

Your insight would be appreciated.
Thanks

Steve Izett
Renesis 4 port RD1C (2.85:1) Inflight Adjustable Prop






--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster