But here's the stock rx8 for leading and trailing.
This very moment, I'm using more of Arron's table in my tune with megasquirt. I still don't know how to tune the spark table yet (with a dyno).
On 2020-01-26 9:38:19 AM, Stephen Izett stephen.izett@gmail.com <flyrotary@lancaironline.net> wrote:
Hi Rich
I should have mentioned that the EC2 & 3 documents I have are both for the A8 versions.
Steve
> On 26 Jan 2020, at 8:15 pm, Stephen Izett stephen.izett@gmail.com wrote:
>
> Hi there Rich
>
> In the EC3 code it suggests that the BUSENSOR can be programmed on various engines:
> "BUSENSOR EQU 0x00 ;0 = NO BACKUP SENSOR, 1 = BACKUP INSTALLED (0xA8,0xA9,AB,AD,B1,B2,B4 0-200 ENGINE ONLY)"
> But in the EC3 document I have, the pinout reads:
> "Pin 6. Crank Angle Sensor (CAS) 2 Destination. Not Applicable on this version. (OPTIONAL)"
> Also in the Document.
> "Note, This version of the EC3 controller is not available with the optional backup crank sensor even though it is shown in the schematic."
> In both the EC2 & 3 documents I have under Sensor wiring it says:
> "If you have installed a backup sensor and have ordered the EC2 with the backup sensor option, the backup sensor must be mounted 90 degrees in advance of the primary sensor.
>
> Cheers
>
> Steve Izett
>
>
>> On 26 Jan 2020, at 10:14 am, A R Goldman argoldman@aol.com wrote:
>>
>> Not a timing issue directly,however—
>>
>> I have Tracy’s ec3 for my renesis. The wiring diagram indicates an input for two CASs however in my rapidly fading memory I seem to remember that only one CAS can be used. Is that correct or can it read two 180 degrees off set.
>>
>> Thanks, Rich
>>
>> Sent from my iPhone
>>
>>> On Jan 25, 2020, at 6:25 PM, Stephen Izett stephen.izett@gmail.com wrote:
>>>
>>> Hi guys
>>>
>>> My apologies, I think Ive asked this some years back, and I’ve had trouble searching the archive, not sure why!
>>>
>>> Lynn has talked from memory about the importance of knowing the timing.
>>> So much appreciate your input Lynn over the years, and sorry for the times I haven’t listened carefully.
>>>
>>> Tracy’s A8 Renesis base timing setup has always run well.
>>> But now as we are extending the envelope I’m interested in what others with Renesis engines/CAS have done with their timing.
>>>
>>> Can anyone with EC2/3 A8 and Renesis CAS comment on any timing adjustments that have made to the base settings.
>>>
>>> Thanks
>>>
>>> Steve Izett
>>>
>>>
>>>
>>> --
>>> Homepage: http://www.flyrotary.com/
>>> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
>>
>>
>> --
>> Homepage: http://www.flyrotary.com/
>> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
>
>
> --
> Homepage: http://www.flyrotary.com/
> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html