Mailing List flyrotary@lancaironline.net Message #65335
From: Bobby J. Hughes bhughes@qnsi.net <flyrotary@lancaironline.net>
Subject: Re: [FlyRotary] Re: Renesis oil pressure
Date: Fri, 15 Nov 2019 07:36:22 -0500
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Thermal pellet and carb jets with racing beat race regulator. Idle at 28 warm and 88-92 psi at 4800-7000 rpm. 

Bobby 

Sent from my iPhone

On Nov 15, 2019, at 2:43 AM, Matt Boiteau mattboiteau@gmail.com <flyrotary@lancaironline.net> wrote:


I installed an RX7 rear regulator and shimmed the front reg with 2 washers. Also installed thermal pellet and weber jets in the e-shaft. Average around 110-115psi during cruise, so I went with an 150psi sensor.

- Matt Boiteau

On 2019-11-14 11:53:30 PM, Neil Unger 12348ung@gmail.com <flyrotary@lancaironline.net> wrote:

Fin,  My renesis starts cold at 150 PSI.  I let it idle at 2200 rpm
until after a few minutes it settles to 80 psi (plus).

Neil.

On 11/15/2019 10:45 AM, Finn Lassen finn.lassen@verizon.net wrote:
> I'm starting to look at engine monitor sensors for my RV-4.
>
> In his Renesis report, Tracy mentioned 100 psi oil pressures. Not
> clear if they dropped after the engine got some hours on it.
>
> What kind of oil pressures are you seeing?
>
> Should I go with a 150 psi or a 100 psi pressure sensor?
>
> Finn
>
>
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:
> http://mail.lancaironline.net:81/lists/flyrotary/List.html

--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster