Mailing List Message #65334
From: Matt Boiteau <>
Subject: Re: [FlyRotary] Re: Renesis oil pressure
Date: Fri, 15 Nov 2019 02:42:56 -0500
To: Neil Unger <>
I installed an RX7 rear regulator and shimmed the front reg with 2 washers. Also installed thermal pellet and weber jets in the e-shaft. Average around 110-115psi during cruise, so I went with an 150psi sensor.

- Matt Boiteau

On 2019-11-14 11:53:30 PM, Neil Unger <> wrote:

Fin,  My renesis starts cold at 150 PSI.  I let it idle at 2200 rpm
until after a few minutes it settles to 80 psi (plus).


On 11/15/2019 10:45 AM, Finn Lassen wrote:
> I'm starting to look at engine monitor sensors for my RV-4.
> In his Renesis report, Tracy mentioned 100 psi oil pressures. Not
> clear if they dropped after the engine got some hours on it.
> What kind of oil pressures are you seeing?
> Should I go with a 150 psi or a 100 psi pressure sensor?
> Finn
> --
> Homepage:
> Archive and UnSub:

Archive and UnSub:
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster