I have attached pics for the installation
of the 2 RX 8 sensors on the plate of the RD=1C. They are
placed 180 degrees apart. I am using one of the 4 locations
where the damper is bolted to the flexplate. I made a C
channel bracket that captures the head of the bolt that
secures the damper. A chunk of aluminum straddles the head of
the bolt and fits into the C channel. It is tapped for 10-32
bolt that is the trigger and can be moved to change timing.
The sensors can be moved in and out to get the right
clearance. I would like to put a scope on the sensors to see
if any of the other 3 bolt heads affect the signal. This is a
mockup engine and has no rotors. I would like to remove the
front and rear stationary gears and lubricate the bearings and
re install the stationary gears and using the starter spin the
assembly over to monitor the sensor with a scope. The
signals will be fed to a Chrysler ignition module and I want
to ensure that they trigger properly. I will have to send
picsin multiple emails Joe Berki 13b P Port Limo EZ