|
Jeff, At last someone did what I did, except my plate is only 3/8 " thick, but then I only use rear mounts with the plate. Very simple and works well to date. I have no idea if foaming is a problem, but have never lost oil pressure, so am assuming there is no problem going on in the sump using standard Renesis oil pickup as I have.
On 7/4/2018 9:49 PM, Jeff Whaley jwhaley@datacast.com wrote:
My aluminum plate is 0.5" thick; you can see it is routed around the rubber mounts, the center is wide open - just a 2.5"-3"" strip of metal left around the oil pan bolts/engine mating surface.
Jeff
-----Original Message-----
Out of curiosity (of course otherwise why would i ask) what is the thickness of your plate between the pan and the engine?
Happy 4th
Rich
-----Original Message-----
From: Jeff Whaley
Sent: July-03-18 10:41 AM
To: 'Rotary motors in aircraft'
Subject: RE: [flyrotary ] RE: Tension Bolts
Rich, my engine is a 1988 13B, normally aspirated, aluminum plate bed mount, so the engine is held in-place by the oil pan bolts. The aluminum plate and engine mount are of my own design and construction.
Jeff
-----Original Message-----
Thanks Jeff
Which model of rotary
What kind of engine mount
Any other modifications to the engine
Rich
-----Original Message-----
From: Jeff Whaley
Sent: July-03-18 9:54 AM
To: Rotary motors in aircraft
Subject: RE: [flyrotary ] RE: Tension Bolts
FWIW: I had one broken tension bolt on spark plug side of the engine; not exactly sure which one but it was around the 10 o'clock position if looking at the bolt heads end. The bolt broke in the threaded portion right where the threads were no longer engaged with the housing ... this was posted way back in 2011 ... see message #53485. Jeff
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
|
|