Received-SPF: pass
 receiver=logan.com; client-ip=209.85.213.180; envelope-from=rwstracy@gmail.com
Subject: Re: [FlyRotary] Re: PSRU oil return line
References: <list-5726769@logan.com>
From: Tracy <rwstracy@gmail.com>
Content-Type: text/plain;
	charset=us-ascii
In-Reply-To: <list-5726769@logan.com>
Message-Id: <D106FD1B-CAE6-47F9-A54B-61E222EA096C@gmail.com>
Date: Fri, 24 Aug 2012 08:14:23 -0400
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Content-Transfer-Encoding: quoted-printable
Mime-Version: 1.0 (1.0)

That would be a fatal mistake!    Yes, you can 'T' the drains but make the r=
ear drain the straight shot through the T.

Tracy

Sent from my iPad

On Aug 24, 2012, at 6:20 AM, My Email <jskmberki@windstream.net> wrote:

> OK. I think I have the inboard ring of the Psru out of phase with the outb=
oard housing if both drains are 1/4" Can I t them with -6 fittings. and al t=
ubing before I route the drain to the al rotor housing? Thanks
>=20
> Joe Berki
> Sent from my iPhone
>=20
> On Aug 23, 2012, at 9:30 PM, Tracy <rwstracy@gmail.com> wrote:
>=20
>> Drilling & taping a hole in the foot of the rear(as in the car) rotor hou=
sing is my favorite spot.   But the return ports are both 1/4" NPT, not 1/8"=
 NPT on one of them.  =20
>>=20
>> Tracy
>>=20
>> Sent from my iPad
>>=20
>> On Aug 23, 2012, at 7:58 PM, <jskmberki@windstream.net> wrote:
>>=20
>>> Where on a 2nd gen engine is the best place for a oil return line from t=
he PSRU drain?   Can I use Al tubing between the 1/4" port and the 1/8" port=
 into a T?
>>>=20
>>> Thanks for any help
>>>=20
>>> Joe Berki=20
>>>=20
>>> --
>>> Homepage:  http://www.flyrotary.com/
>>> Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/Li=
st.html
>>=20
>> --
>> Homepage:  http://www.flyrotary.com/
>> Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/Lis=
t.html
>=20
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List=
.html