Drilling & taping a hole in the foot of the rear(as in the car) rotor housing is my favorite spot.   But the return ports are both 1/4" NPT, not 1/8" NPT on one of them.  

Tracy

Sent from my iPad

On Aug 23, 2012, at 7:58 PM, <jskmberki@windstream.net> wrote:

> Where on a 2nd gen engine is the best place for a oil return line from the PSRU drain?   Can I use Al tubing between the 1/4" port and the 1/8" port into a T?
>
> Thanks for any help
>
> Joe Berki
>
> --
> Homepage:  http://www.flyrotary.com/
> Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html