The hole on the block is the coolant drain hole.

Ken Powell
> On 1/21/04 4:33 PM, "Scott" <squiggles@yahoo.com> wrote:
>
> > I have attached two photos...
> >
> > On the "where does this hole go" I would like to know
> > where the lower left hole of the side engine mount
> > hole goes.
> >
> > On the "how far setback" I am contemplating using
> > these holes as part of an engine mounting point.  I
> > was hoping somebody had already gone this route and
> > had determined the offset of the front cover bolt
> > holes from the end housing holes.
> >
> > Thanx...
> >
> > -Scott
> >
> > =====
> > Thank You.
> >
> > Regards,
> > Scott Stout
> >
>
> 12345 holes are where the AC compressor mount goes. You can measure the
> difference with straight ruler and calipers. I did it, but forgot. Most of
> people use this  area for alternator mounting pad. I'm loosing my sleep over
> the design myself.
> The other hole, I don't know. On mine, there is a long hex-headed stud.
> Bulent
>

> >>  Homepage:  http://www.flyrotary.com/
> >>  Archive:   http://lancaironline.net/lists/flyrotary/List.html