This is hard for me to visualize as well. Perhaps
if you get a chance, you could snap a picture from the top.
Did you get 43 in. from #1 secondary to #2
secondary?
Bryan
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Bill Bradburry
Sent: Monday, February 15, 2010
11:29 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: rpm vs
Power was : Throttle limits was Re: N.A. Renesis to turbo
Dennis,
I just looked at your picture again…the
secondary look much longer than the primaries. It may be an optical
illusion??? I bet you mean 1 1/8 id??
Bill B
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Dennis Haverlah
Sent: Monday, February 15, 2010
11:03 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: rpm vs
Power was : Throttle limits was Re: N.A. Renesis to turbo
All my tubes are the same
length and the same diameters. I can check but I think they were 1 1/4
id. and 1 1/4 od.
Bill Bradburry wrote:
Dennis,
Aren’t your primary and secondary tubes
different lengths from rotor face to rotor face? If so, what are
the two lengths? Are they different diameters?
Bill B