----- Original Message -----
Sent: Saturday, November 28, 2009 1:21
PM
Subject: [FlyRotary] Gasket removal
I have been scraping and washing in a parts washer the forward end
housing
> and the gasket for the water punp and the front cover are
very subborn. The
> only thing that seems to work is a dremel sanding
drum. Is there an eaiser
> way? I am worried about maring the cast iron
although the new gasket
> should seal adequately. Thanks for any help.
>
> Joe Berki
> Limo EZ
>
A cup style wire brush with twisted wire sets will take anything off of
cast iron without hurting it.
Not for any other surface. Just cast iron. Use in a low to medium speed
drill motor.
A face shield and safety classes. Thick gloves and long sleeves.
Lynn E. Hanover
No virus found in this incoming message.
Checked by AVG -
www.avg.com
Version: 9.0.709 / Virus Database: 270.14.86/2533 - Release
Date: 11/28/09 14:34:00