flyrotary@lancaironline.net Mailing List Archive

Here’s a correction to the Medeco cam lock part numbers I’d provided earlier and additional installation instructions. The part numbers are still different than what we’d ordered while developing this concept – but, this is what we’d order today after all we’ve learned. Hope this is more helpful…

Valin

--------------------------------------------------------------------------------------------------

Here’s how Allyson and I set up to lock our Legacy’s canopy…

First, we purchased this Medeco high security cam lock:

Here are the Medeco lock’s specifications:

This Medeco Cam Lock can be ordered from the RA-Lock Company of Cedar Hill, Texas (800.777.6310). The lock is $23.25, the cam is $0.59, and the keys are $1.75 each.

We placed the cam lock just behind the latch handle assembly. This allows us to hide the key hole behind the latch handle when in the normal latch handle position.

With the canopy latch handle in its normal aft trailing position, trace its outline onto the fuselage skin with a marker pen. Draw a horizontal line down the center. Measure two inches from the latch handle body edge and mark the center of the hole for the lock. Drill a ¾” hole for the cam lock at this location. This hole is big enough for the body but not the head of the lock. Place the lock in this hole with the head against the fuselage skin and draw a circle around the head. Grind away the outer skin of the fuselage to this line so that the cam lock rests flush with the outer skin. De-core about a half inch into the fuselage skin around the lock head. This area will eventually be filled with epoxy/flox mixture for final bonding.

We built a strong fuselage housing for the lock out of ¼” thick phenolic. The body of the lock has two flat sides that need to be firmly against phenolic sheet to ensure that the entire lock housing can not be forced to rotate. The phenolic housing sides are basically one inch square pieces and the flanges are 45 deg triangles with one inch sides.

The lock head face should be bonded in flush with the fuselage skin. Tape over the key hole to ensure no epoxy/flox enters during bonding. We put the fuselage on its left side for this so that gravity was more helpful and duct-taped a piece of wood against the hole on the outside to provide a platform to rest the lock on and ensure it was perfectly flush with the fuselage skin.

Before bonding it all in, hold the lock with the cam in position to ensure that the rotational orientation for locked and unlocked positions is correct and that the cam has been bent to the correct shape. We hammered the cam out straight and then bent it about two inches from the attached end to get the right geometry to block the canopy latch torque tube. The key hole slot should be approximately vertical and at the bottom for the locked position and horizontal and on the left side for the unlocked position.

Bond everything in place with an epoxy/flox mixture. Be sure to tape over everything you don’t want epoxy on.