When I built my plane, I very carefully labeled all my wires,
printing out a label for each end, cutting it out, and heat shrinking it with
clear heat shrink tubing. Unfortunately, I used a label printer that used
thermal printer on the tape, and with time, and the heat under the cowl, most
of the labels are turning black and unreadable.
It is too late for my plane, but I know there are many others in
the chapter that still have the wiring to do. There is a better alternative, a
printer that uses THERMAL TRANSFER printing, and will print directly on heat
shrink tubing. The tubing is then slipped over the wire, and heat shrunk
into place. The printing shrinks with the tubing, and you get a very
professional label, that won't go away. My proposal is this:
1. The Chapter buys 10 heat shrink cartridges, and gets a
FREE Dymo Rhinopro 5000 labeler at this web address
http://www.buyheatshrink.com/dymo-label-writer/dymo-replacement-labels.htm#heatshrink
2. A Chapter member wants to use the machine -- he/she buys
from the chapter the appropriate cartridge, and borrows the labeler. When
done, he removes his cartridge from the machine and returns it to the chapter
or the next member that wants to use it.
Net result: Members get professional quality labeling, the chapter
ends up with no net expense ( about $300 upfront cost)
Bill Schertz
Plane currently grounded because BlueMountain unit out for repair.