|
Kelly:
Yes I was able to locate a local distribuitor
for the stainless version of the elbows like shown on the SDFI
page.
The 2 inch ID 45 degre ells run about 3/16th
thick or more wall, and are quite heavy OD is about 2.5 or more.
It is listed as a schedule 40 pipe.
I may look in to a schedule 5 pipe. I am not up to
speed with plumbing nomenclature but I belive a schedule 5 is thiner than a
40 and closer to our needs.
Michael
----- Original Message -----
Michael,
If you are handy with a welding torch you
might consider building
your exhaust header using the method in the link below......The
"Weld
Els" are also available in stainless and could be used for the first
part
(hottest) of the manifold and thinner gauge tubes for the
remainder......
Mcmaster-Carr has a large selection of sizes an
alloys........FWIW
|