Mailing List flyrotary@lancaironline.net Message #35318
From: Dennis Haverlah <clouduster@austin.rr.com>
Subject: engine/cowl installation cont.
Date: Fri, 02 Feb 2007 21:53:11 -0600
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
 Message Header

Undecoded Message
Attached are more pictures.

1.  Top of engine looking down from left side. The yellow tank on top of the engine is the oil reservoir for the 2 cycle oil fed to the injection pump.
Also  the fuel rails and fuel plumbing is near the top of the photo.  The alternator is RX-8 100 amp.  Upper left shows the AN-20 water hose going down to the radiator.  The water/air tank is at the top extreme left.  The relocated starter is shown at the bottom right corner.
2.  Right side shows the intake manifold and throttle body added to the stock RX-8 intake that was cut off just above the injector boss.
More of the AN-20 hose system is also shown.  The exhaust manifold is stock RX-8 with 2 egt's added to the left and right exhaust ports.
3.  Right side again with a better view of the exhaust system. I hope to remove the heat shields from the muffler and take another picture as soon as it gets warmer.  - maybe Sunday.
Image
1422,lt. top (Small).JPG
Image
1423 rt top(Small).JPG
Image
1424 ,rt exhaust(Small).JPG
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster